Surface hardening of a ductile-cast iron roll using high-energy electron beams
SCIE
SCOPUS
- Title
- Surface hardening of a ductile-cast iron roll using high-energy electron beams
- Authors
- Suh, D; Lee, S; Kwon, S; Koo, Y
- Date Issued
- 1997-07
- Publisher
- MINERALS METALS MATERIALS SOC
- Abstract
- The effects of high-energy electron beam irradiation on surface hardening and microstructural modification in a ductile cast iron (DCI) roll are investigated in this study. The DCI roll samples were irradiated by using an electron accelerator (1.4 MeV), and then their microstructures and hardnesses were examined. Upon irradiation, the unirradiated microstructure containing graphites and the tempered bainite matrix was changed to martensite, ledeburite, and retained austenite, together with the complete or partial dissolution of graphites. This microstructural modification improved greatly the surface hardness due to transformation of martensite whose amount and type were determined by heat input during irradiation. In order to investigate these complex microstructures, a simulation test including thermal cycles of abrupt heating and quenching was carried out. The simulation results indicated that the irradiated surface was heated up to about 1100 degrees C to 1200 degrees C and then quenched to room temperature, which was enough to obtain surface hardening through martensitic transformation. Thermal analysis of the irradiated surface layer was also carried out using a finite difference method to understand the surface hardening of the DCI roll and to compare with the simulation test results.
- URI
- https://oasis.postech.ac.kr/handle/2014.oak/21263
- DOI
- 10.1007/s11661-997-0212-5
- ISSN
- 1073-5623
- Article Type
- Article
- Citation
- METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, vol. 28, no. 7, page. 1499 - 1508, 1997-07
- Files in This Item:
-
Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.