Open Access System for Information Sharing

Browse by Researchers

LEE, SUNG HAK(이성학)

Department: Dept of Materials Science & Engineering(신소재공학과)

Major(s): -

E-Mail

Homepage

Co-researchers

Keyword

Publication & Time Cited Count (For the Last 5 years)

Results 1-11 of 11 (Search time: 0.001 seconds).

Applied search limites :

Subject : MICROSTRUCTURE Subject : TENSILE PROPERTIES Subject : MECHANICAL-PROPERTIES

Article

Strength-ductility enhancement in multi-layered sheet with high-entropy alloy and high-Mn twinning-induced plasticity steelSCIESCOPUS

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, vol. 822, 2021-08

Article

Cryogenic-temperature fracture toughness analysis of non-equi-atomic V10Cr10Fe45Co20Ni15 high-entropy alloySCIESCOPUS

JOURNAL OF ALLOYS AND COMPOUNDS, vol. 809, 2019-11

Article

Role of brittle sigma phase in cryogenic-temperature-strength improvement of non-equi-atomic Fe-rich VCrMnFeCoNi high entropy alloysSCIESCOPUS

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, vol. 724, page. 403 - 410, 2018-05

Article

Cryogenic strength improvement by utilizing room-temperature deformation twinning in a partially recrystallized VCrMnFeCoNi high-entropy alloySCIESCOPUS

Nature Communications, vol. 8, 2017-06

Article

Effects of Annealing Treatment Prior to Cold Rolling on Delayed Fracture Properties in Ferrite-Austenite Duplex Lightweight SteelsSCIESCOPUS

METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, vol. 47A, no. 2, page. 706 - 717, 2016-02

Article

Improvement of interfacial bonding strength in roll-bonded Mg/Al clad sheets through annealing and secondary rolling processSCIESCOPUS

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, vol. 628, page. 1 - 10, 2015-03-25

Article

Effects of Annealing Treatment Prior to Cold Rolling on the Edge Cracking Phenomenon of Ferritic Lightweight SteelSCIESCOPUS

METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, vol. 45A, no. 9, page. 3844 - 3856, 2014-08

Article

Effects of aluminum content on cracking phenomenon occurring during cold rolling of three ferrite-based lightweight steelSCIESCOPUS

Acta Materialia, vol. 61, no. 15, page. 5626 - 5635, 2013-09

Article

Analysis and Estimation of Yield Strength of API X80 Linepipe Steel Pipe by Low-Cycle Fatigue TestsSCIESCOPUSKCI

METALS AND MATERIALS INTERNATIONAL, vol. 18, no. 4, page. 597 - 606, 2012-08

Article

Direct observation of microfracture process in metallic-continuous-fiber-reinforced amorphous matrix composites fabricated by liquid pressing processSCIESCOPUS

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, vol. 527, no. 4-5, page. 941 - 946, 2010-02-15

Article

Effects of ferrite grain size and martensite volume fraction on dynamic deformation behaviour of 0 center dot 15C-2 center dot 0Mn-0 center dot 2Si dual phase steelsSCIESCOPUS

MATERIALS SCIENCE AND TECHNOLOGY, vol. 21, no. 8, page. 967 - 975, 2005-08

Open Access System for Information Sharing

Co-researchers

Keyword

Publication & Time Cited Count (For the Last 5 years)

Date issued

Type

Subject

Journal Registered

Browse