Open Access System for Information Sharing

Browse by Researchers

KIM, HYOUNG SEOP(김형섭) orcid researcherid google scholar scopus

Department: Ferrous & Eco Materials Technology(친환경소재대학원)

Major(s): -

E-Mail

Homepage

Co-researchers

Keyword

Publication & Time Cited Count (For the Last 5 years)

Results 1-19 of 19 (Search time: 0.002 seconds).

Applied search limites :

Date Issued : [2010 TO 2019] Type : Article Type : Article Journal Registered : scie Subject : TENSILE PROPERTIES

Article

Cryogenic-temperature fracture toughness analysis of non-equi-atomic V10Cr10Fe45Co20Ni15 high-entropy alloySCIESCOPUS

JOURNAL OF ALLOYS AND COMPOUNDS, vol. 809, 2019-11

Article

Role of brittle sigma phase in cryogenic-temperature-strength improvement of non-equi-atomic Fe-rich VCrMnFeCoNi high entropy alloysSCIESCOPUS

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, vol. 724, page. 403 - 410, 2018-05

Article

High-Entropy Alloys: Potential Candidates for High-Temperature Applications – An OverviewSCIESCOPUS

ADVANCED ENGINEERING MATERIALS, vol. 20, no. 1, page. 1700645 - 1700645, 2018-01

Article

Mechanical properties and deformation twinning behavior of as-cast CoCrFeMnNi high-entropy alloy at low and high temperaturesSCIESCOPUS

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, vol. 712, page. 108 - 113, 2018-01

Article

Key factors of stretch-flangeability of sheet materialsSCIESCOPUS

JOURNAL OF MATERIALS SCIENCE, vol. 52, no. 13, page. 7808 - 7823, 2017-07

Article

Cryogenic strength improvement by utilizing room-temperature deformation twinning in a partially recrystallized VCrMnFeCoNi high-entropy alloySCIESCOPUS

Nature Communications, vol. 8, 2017-06

Article

Novel 1.5 GPa-strength with 50%-ductility by transformation-induced plasticity of non-recrystallized austenite in duplex steelsSCIESCOPUS

Scientific Reports, vol. 7, no. 1, 2017-04

Article

On the strain rate dependent deformation mechanism of CoCrFeMnNi high-entropy alloy at room and liquid nitrogen temperaturesSCIESCOPUS

Materials Research Letters, vol. 5, no. 7, page. 472 - 477, 2017-03

Article

Quasi-static and dynamic deformation mechanisms interpreted by microstructural evolution in TWinning Induced Plasticity (TWIP) steelSCIESCOPUS

Metallurgical and Materials Transactions A, vol. 684, page. 54 - 63, 2017-01

Article

Thermally activated deformation and the rate controlling mechanism in CoCrFeMnNi high entropy alloySCIESCOPUS

Materials Science and Engineering: A, vol. 682, page. 569 - 576, 2017-01

Article

Effects of Annealing Treatment Prior to Cold Rolling on Delayed Fracture Properties in Ferrite-Austenite Duplex Lightweight SteelsSCIESCOPUS

METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, vol. 47A, no. 2, page. 706 - 717, 2016-02

Article

Contributions of different strengthening mechanisms to the shear strength of an extruded Mg-4Zn-0.5Ca alloySCIESCOPUS

PHILOSOPHICAL MAGAZINE, vol. 95, no. 31, page. 3452 - 3466, 2015-11-02

Article

Effect of Homogenization Treatment on the Microstructure and Mechanical Property Evolutions of As-Cast Al-Cu Alloy during High-Pressure TorsionSCIESCOPUS

Materials Transactions, vol. 55, no. 9, page. 1405 - 1413, 2014-09

Article

Quasi-static and Dynamic Compressive Properties of Ti-Based Amorphous Alloys Modified from Conventional Ti-6Al-4V Titanium AlloySCIESCOPUS

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, vol. 607, page. 197 - 205, 2014-06-23

Article

Effects of Inclusions on Delayed Fracture Properties of Three TWinning Induced Plasticity (TWIP) SteelsSCIESCOPUS

METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, vol. 44, no. 2, page. 776 - 786, 2013-02

Article

Correlation of Microstructure with Mechanical Properties of Zr-Based Amorphous Matrix Composite Reinforced with Tungsten Continuous Fibers and Ductile DendritesSCIESCOPUS

METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, vol. 43A, no. 11, page. 4088 - 4096, 2012-11

Article

Analysis and Estimation of Yield Strength of API X80 Linepipe Steel Pipe by Low-Cycle Fatigue TestsSCIESCOPUSKCI

METALS AND MATERIALS INTERNATIONAL, vol. 18, no. 4, page. 597 - 606, 2012-08

Article

Hot deformation of ultrafine-grained Al6063/Al2O3 nanocompositesSCIESCOPUS

JOURNAL OF MATERIALS SCIENCE, vol. 46, no. 14, page. 4994 - 5001, 2011-07

Article

Microstructure and mechanical properties of oxide-dispersion strengthened Al6063 alloy with ultra-fine grain structureSCIESCOPUS

METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, vol. 42A, no. 3, page. 816 - 824, 2011-03

Open Access System for Information Sharing

Co-researchers

Keyword

Publication & Time Cited Count (For the Last 5 years)

Date issued

Type

Subject

Journal Registered

Browse